Need help?Do you have a question about the GreenWorks STF307 and is the answer not in the manual?
General| Voltage | 24V |
|---|---|
| Power Source | Battery |
| Cutting Width | 12 in. |
| Cutting Path | 12 in. |
| Weight | 6.4 lb |
This machine is used to cut grass, light weeds, and other similar vegetation at or around ground level.
Figure 1 - 15. Lists parts: Rear handle, Trigger, Lock-out button, Auxiliary handle, Upper shaft, Lower shaft.
Read and understand all instructions before using this product. Failure to follow may result in shock, fire, or personal injury.
Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
Servicing requires extreme care and knowledge and must be performed only by a qualified service technician.
Discard all toxic materials in a specified manner to prevent contamination of the environment.
Make sure that you correctly assemble the machine before use. Unpack and remove all parts.
Steps to attach the guard, assemble the shaft, and attach the auxiliary handle.
Instructions for installing and removing the battery pack from the machine.
Instructions on how to start the string trimmer using the lock-out button and trigger.
Tips for operating the machine, including keeping clearance and handling grass winds.
Techniques for cutting grass effectively, including tilting the machine and using the cutting line tip.
Only dealer or approved service center can do maintenance not in this manual. Check bolts and screws.
Clean with a moist cloth. Do not use aggressive detergents or spray water on motor/electrical parts.
Procedure for replacing the spool and the cutting line.
Instructions for removing the old bump knob and installing a new one.
Possible causes and solutions when the machine does not start when the trigger is pushed.
Solutions for when the line does not forward, keeps breaking, or is tangled on the spool.
Causes and solutions for the motor being overloaded or the battery/machine being too hot.
Specifications like motor type, no load speed, cutting diameter, and weight.
Temperature ranges for storage, operation, and battery charging/discharging.
Details the three-year warranty, items not covered, and helpline information.
Diagram showing all parts of the string trimmer with corresponding part numbers and quantities.
To Next Page