Operation manual SP 9 - Compact
CHAPTER II – GENERAL SAFETY – Page 9
2.14 PAY ATTENTION TO THE ELECTRICAL WIRES
Pay close attention especially when you maneuver near the electrical wires. The electrical
shock exists even if you do not touch them. They may cause serious injury or even death.
Especially pay attention if the tractor equipped with the accumulator charging unit.
Be careful if it is turn-wrest plough or the rear part can be hydraulically turned up.
Keep the safety distance between
the plough
and electrical wires
especially during the maneuvered
as well as during going up and
down.
If the machine touches electric wire
s we
must stop the machine and put on th
e
brakes.
Make sure that you can move out of the present situation without touching
the
electrica
l wire
s.
Do not touch the electric wires till th
e voltage has been eliminated.
Everybody who tries to approach the machine
must be warned and asked not
to touch the
machine till the voltage has been elim
inated.
Take into the consideration the radio or CB aerials or any other later mounted
supplements which can change the height of the
machine.
2.15 SIGNAL THE POSITION OF THE MACHINE
Systematically examine the condit
ion of the lamps and reflectors according
to the rules. Use them accordingly, clean them, they must work correctly
and be seen by other drivers.
Keep the safety equipment in good condition.
Clean the equipment from dirt, dust and other residues.
Change the burnt lamps, repair or ch
ange damaged or lost signals.
Head lamps, flash signals, blinker lights and red reflectors must be
used
accordingly on the tractor and on th
e plough as well during the day time
and
during the night.
Place the slow vehicle sign or use the head lights during transporting on the
roads.
The signals kit can be purchased at the GRÉGOIRE-
BESSON dealer.
The owner or the user
are responsible for well-seen signals during the traction
and for keeping laws and rules.
To Next Page
Loading...