Operation manual SP 9 - Compact
CHAPTER V – ATTACHEMENT AND DISENGAGEMENT – Page 6
5.2.8. Arrester for the turning equipment
The SP 9 Compact plough has arrester for turning equipment. This unit can be disengaged
only on the ground directly before the beginning of the plough. After the finishing of the
plough the arrester again must work. With the help of it any danger of accident can be
avoided because of the wrong operation which can occur during the transporting and in this
way the disengaged plough motion can be prevented.
In the fixed position the
axle (20) penetrates into the holder (21) which provides the fastening.
The position of the axle can be directed by a lever (22) which can be found at the front of the
turning unit.
The axle must be fixed before the plough disengaging.
To Next Page
Loading...