To Next PageTo Next Page
Need help?Do you have a question about the Grifco GLD-SDO and is the answer not in the manual?
General| Manufacturer | Grifco |
|---|---|
| Drive Type | Chain Drive |
| Remote Control | Yes |
| Operating Voltage | 230-240V AC |
| Voltage | 230-240V AC |
| Remote Controls | 2 |
| Security | Rolling code |
Explanation of safety symbols and signal words used throughout the manual.
Procedure for connecting the operator unit to the door rail assembly.
Instructions for adjusting the chain tension and spring compression.
Securing the rail assembly to the operator motor unit.
Determining the correct mounting location for the header bracket.
Mounting the header bracket securely to the structural support.
Connecting the rail assembly to the installed header bracket.
Placing and aligning the operator unit prior to mounting.
Securing the operator unit to the ceiling structure.
Attaching the bracket to the door for connection to the operator arm.
Connecting the door arm to the operator trolley.
Procedures for testing and operating the manual door release mechanism.
Setting the door's open/closed limits and force adjustments.
Installation and wiring of safety beams for obstruction detection.
Testing the functionality of the safety beam system.
Configuring the automatic closing feature based on a time delay.
Steps to enable and set the desired time for automatic closing.
Procedure to disable the automatic closing feature.
