Page 6
SETTING UP YOUR BBQ
OIL CHANNEL, GRILL, FLAME TAMER AND
FAT CUP PLACEMENT
Order of how things go into the barbecue:
1. Oil Channel inserted into front of frame with end of channel going
through hole in side of barbecue frame. (Fig.5)
2. The flame tamers should be placed underneath the grills but above
the oil channel.
3. Grillstream Grills always go to the left hand sides. (Fig.6)
4. Griddles are always on the right.
5. Attach fat cup to side of barbeuce underneath the side shelf. (Fig.7)
NOTE:
a. Ensure that your grills incline from front to back to the fat
collecting channel at the front of the barbecue.
b. There may be a slight movement in the grill bars while cooking, this
is normal and will not affect the way the Grillstream system works.
(Fig.5)
2 X GRILLSTREAM GRILLS
1/3 SOLID GRIDDLE PLATE
(Fig.6)
Grillstream Grills fit directly on top of each other - do not offset them.
OIL CHANNEL
(Fig.7)
FAT COLLECTION
Using the fat collection cup
SECURING THE HOSE AND REGULATOR ASSEMBLY
Screw on hose connection (Fig. 4)
- The bbq’s manifold connection is 1/4” Male Thread BSP
- The connection between the hose and regulator and the bbq should
always be tightened with a spanner. ‘Finger tight’ only is NOT sufficient.
TESTING FOR LEAKS - DO THIS BEFORE USING YOUR BBQ
NOTE - DO NOT test for gas leaks with an open flame.
If you smell gas, turn off at the source
Before first use and periodically during the season, or whenever a gas
cylinder is changed, you must check for gas leaks.
Do so by:
- Turn on the gas cylinder
- Turn all gas valves on the bbq to the off position
- Brush a soap solution of one part liquid detergent and one part water
to all gas connections
- The presence of bubbles indicates a leak. Tighten or repair as necessary
- Under no circumstances should a naked flame be used to check for leaks
- If a gas odour is present and no leaks can be found, do not use the
bbq. Turn the gas off at the source, disconnect the hose and
immediately contact your bbq dealer or place of purchase for
assistance
N.B. LEFT HAND THREAD CONNECTION OF HOSE TO ADAPTOR
N.B. IMMEDIATLY PERFORM GAS LEAK CHECK AS SHOWN ON PAGE 2 AND 31
TO ENSURE SAFE CONNECTION.
(Fig. 4)
GSG66SS