16
TROUBLESHOOTING
PROBLEM CAUSE REMEDY
Air leaks at fittings Fittings loose Tighten fittings
Air leaks at compressor head Head bolts loose Tighten bolts securely
Air blows out of inlet filter Damaged reed valve Have unit serviced by authorized
service dealer
Air intake filter dirty Clean or replace filter
Air leaks Check unit for leaks and correct
as needed.
Air hose too small or too long Use large diameter air hose and
larger capacity fittings.
Insufficient pressure at air tool or
accessory
Reed valve worn or damaged Have authorized service dealer
replace.
Air intake filter dirty Clean or replace filter
Compressor positioned on uneven
surface
Position compressor on level
surface
Oil leakage Have authorized service dealer
repair unit.
Oil consumption excessive
Worn cylinder or piston rings. Have authorized service dealer
repair unit.
Crankcase oil appears milky when
dipstick is checked
Water in oil from condensation Change crankcase oil.
Moisture in discharge air Excessive condensation in air tank Drain tank more frequently. Tip
unit when draining tank to drain
all water.
To Next Page
Loading...