AUTOMATIC DARNING
-27-
a=Length of darning
1. Adjust slide on base according to the length of
darning
2. Pass upper thread through the hole of buttonhole
foot and attach buttonhole foot to machine. Bring
upper and bobbin threads to the left under foot.
3. Position fabric under presser foot so that the
the center line mark is in the center of the needle
opening in the buttonhole foot.
With the main part of the foot pushed to the back
lower the presser foot lever.
4. Lower the buttonhole foot lever so it is positioned
behind the raised finger on the foot.
If this lever in-positioned, flash BH foot mark
alarmed on LCD screen.
20
20
To Next Page
Loading...
