IMPORTANT SAFETY INSTRUCTIONS:
When you are use an electrical appliance, basic safety precautions should always be
adhered to as follows: Read all instructions before using this sewing machine.
Notes on safety for household sewing machines according to IEC/EN 60335-2-28.
DANGER– To reduce the risk of electric shock:
1. A sewing machine should never be left unattended when
plugged in. Always unplug this sewing unplug this sewing
machine from the electric outlet immediately after using
and before cleaning.
2. To avoid electrical shock never put the machine or the
mains cable or mains plug into water or other liquids.
WARNING- to reduce the risk of burns,fire,electrick
shock , or injury to persons:
1. This sewing machine is not intended for use by persons
(including children) with reduced physical,sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been givensupervision or instruction
concerning use of the sewing machine by a person
responsible for their safety.
2. Children should be supervised to ensure that they do not
play with the sewing machine.
3. Use this sewing machine only for its intended use as
described in this manual.. Use only attachments
recommended by the manufacturer as contained in this
manual.
4. The user must exercise adequate caution with regard to
the up and down moving of the needle and constantly
observe the sewing area during work.
5. When leaving the machine, during maintenance work or
when changing mechanical parts or accessories,always
disconnect the machine by pulling out the main plug.
6. The tension of the drive belt must only be adjusted by a
specialist mechanic.
7. The machine must be put into operation according to the
indications on the specification plate.
8. Never drop or insert any object into the any opening.
9. Do not use the sewing machine if:
a. there is a visible damage,
b. its function is disturbed,
c. it is wet, e.g. with condensation.
d. where aerosol spray products or oxygen is being
administered.
e. in outdoors.
10. Never operate this sewing machine if it has a damaged
cord or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water. Return the
sewing machine to the nearest authorized dealer or
service center for examination, repair, electrical or
mechanical adjustment.
11. To disconnect the sewing machine , turn the on/off switch
to off ("O") position, then remove plug from outlet .
12. Do not unplug by pulling on cord. To unplug, grasp the
plug, not the cord.
13. Switch off or unplug the appliance when leaving it unattended,
or making any
adjustments in the needle area,such as
threading needle,changing needle, threading bobbin ,
or replacing presser foot and bulb and before carrying
out maintenance.
14. If this appliance is used for another purpose than
intended or if it is wrongly operated, we will not accept
any liability for any damage caused.
15. To avoid the risk of electric shock, do not open the
machine, There are no parts inside the machine which
the user can repair. This is solely the responsibility of our
qualified service staff.
16. Be sure to use only original parts.
17. Keep fingers away from all moving parts. Special care is
required around the sewing machine needle.
18. Do not use bent needles.
19. Do not pull or push fabric while stitching. It may deflect
the needle causing it to break.
20. Never sew with a damaged needle plate as this can
cause needle to break .
21. This sewing machine is designed for mains supply with a
nominal voltage of ± 10% and a rated frequency of ± 4%.
22. If the power plug or power cords damage, it must be
replaced by the Manufacturer or it's service agent or a
similarly qualified person.
23. Attention the following to avoid injury:
a. Unplug the foot controller of the appliance when leaving
it unattended.
b. Unplug the foot controller of the appliance before
carrying out any maintenance.
24. The LED lamp maximum power is 3 W, if the LED lamp is
damaged , you should not use the sewing machine and
send it to the manufacture or service agent to repair or
replace it.
25. This sewing machine uses the foot control model HKT72C
or FL3902.
Environment:
The recommended environment is
-Ambient temperature 20°C to 30°C
-Humidity 20% to 80%.
-Storage temperature - 25°C to + 60°C
This sewing machine is a high-quality electronic-mechanical
appliance; it is a machine for supervised use at home. It
should be operated in such a way that it is not subjected to:
dust, severe dampness,direct sunlight, static electricity, heat -
producing object, corrosive chemicals or liquids.
For ventilation purposes the machine must be used on a free
surface, which is both firm and even.
This sewing machine is a suppressed and immune to
interference ;however , it should not be operated near
electronic devices such as radios,TVs,PCs,broadcasing
transmitters etc.
Care of the sewing machine:
Always protect the machine against damage which might
occur by hitting or dropping.
Cleaning:
Housing: To clean the housing, use a dry, clean and soft cloth
which is free of fluff.To remove any of stubborn dirt, use a soft
cloth with alcohol .
Please note!
Do not use any insecticides or chemical products such as
petrol (gasoline) or thin chemicals for cleaning the housing.
Run this appliance for at least 2 minutes
before actual sewing.
This equipment is marked with the recycling
symbol. Do not dispose this product as
unsorted municipal waste. Collection of such
waste separately for special treatment is
necessary.If in doubt please contact your
retailer for guidance.(European Union only)
SAVE THESE INSTRUCTIONS
Disposal
To Next Page
Need help?
General
