1.0 PACKING
Check carefully the content of the box and in case of damage contact your forwarder immediately.
The following items are included in the box:
n° 1 instructions leaflet;
n° 1 ACROBAT FE;
n° 2 XLR 3 poles plugs (1 male + 1 female);
n° 1 power supply plug;
2.0 SAFETY
Disconnect the lantern from mains supply before replacing the lamp.or servicing the unit.
- This projector has been designed for use in interior: the unit shall be shielded or protected by
ingress of water if used outdoor.
- For safety operation, max. ambient temperature must not exceed 50°C.
- Caution: the surface temperature of the projector can reach 90°C
- Caution: hot lamp; make sure the lamp is cold before attempting to remove it: wait for about 10
minutes.
- Caution: it is strongly recommended that a safety-chain or wire is attached to this projector and
secured to the main mounting framework to arrest the fall of the unit in the unlikely event that the
primary mounting arrangement should fail.
3.0 INSTALLATION
3.1 Movement arrest system removal
A pan movement arrest system has been provided in order to avoid damages to the unit during
transport. Move the two arresting knobs before attempting to switch the unit on.
Unfasten the two knobs indicated by the arrows in pictures 1 and 2 and move them to the very end
of the outer profile;
pict 1
pict 2
9
To Next Page
Loading...
