GB
90
Trouble shooting
Problem Possible cause Remedy
Trimmer vibrates
Spool is dirty
Clean spool (see “Cleaning and
maintenance“)
Spool is defective
Exchange spool (see Cleaning
and maintenance „Exchanging
the line spool“)
Trimmer does not start
No mains power
Check cable, line, plug; repair by
qualied electrician
ON / OFF switch defec-
tive
Repair by After-Sales Service
Worn carbon brushes
Motor defective
Poor cutting perform-
ance
Line spool does not have
sufcient line
Lengthen cutting line
(see “Operation”)
or exchange spool (see Clea-
ning and maintenance „Exchan-
ging the line spool“)
Line has not been con-
ducted out of the spool or
only on one side
Remove spool and lace line
through opening outwards and
return spool.
Weight .............................................2,5 kg
Dual line............... 2 x 5 m, fully automatic
Cutting circle dual line ....................300 mm
Line thickness dual line ................ 1,4 mm
Protection Class .................................... II
Sound power level (LWA)
guaranteed..................................96,0 dB (A)
measured ...........94,0 dB (A); KwA =1,93 dB
Sound pressure level
(LpA) ..................74,0 dB (A); KpA =1,93 dB
Vibration (an)
upper handle ............3,7 m/s
2
; Kn=1,5 m/s
2
additional handle .......1,6 m/s
2
; Kn=1,5 m/s
2
Noise and vibration ratings have been
determined pursuant to the standards and
regulations specied in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further de-
velopment without notice. All dimensions,
references and information in this instruc-
tion manual are therefore not guaranteed.
Legal claims made on the basis of the
instruction manual can therefore not be
considered as valid.
To Next Page
Loading...
Need help?
General
