Operation (cont'd)
i. Light the pilot burner by the procedure that applies to your unit.
(1)
With Basotrol standing pilot ignition system:
(a) Locate the red reset button on the automatic gas valve inside the control
housing. You can reach the button through the hole below the pressure gauge.
(b)
Hold a flame to the pilot burner and press down the reset button to start the flow
of gas. Continue to hold the reset button down
burner is lit.
(c) Release the button. The pilot burner should stay lit.
(2)
With Honeywell pilot ignition system:
(a) To reach the "ON/PILOT/OFF" knob, remove the cover of the control housing.
(b) Set the knob to "PI LOT".
(c) Hold a flame to the pilot burner and press down the knob to start the flow of
gas. Continue to hold the knob down for 60 seconds after the pilot burner is lit.
(d) Release the knob. The pilot should stay lit.
(e) Set the knob to "ON". Then replace the cover of the control housing.
(3)
For all units, if pilot requires relighting:
(a) Set both the ON/OFF switch and the thermostat dial to their "OFF" positions.
(b) Wait 5 minutes.
(c) Light the pilot by the appropriate procedure above.
j. To light the main burner and start heating the kettle, after the pilot burner is lit:
(1)
Press the ON/OFF switch to "ON".
(2)
Turn the thermostat dial to the desired setting.
L THE KETTLE WHEN COOKING, HOLDING OR
CLEANING. KEEP LIQUIDS A MINIMUM OF 2-3" (5-8 CM) BELOW THE
KETTLE BODY RIM TO ALLOW CLEARANCE FOR STIRRING, BOILING
PRODUCT AND SAFE TRANSFER.
CAUTION: KEEP FLOORS IN FRONT OF KETTLE WORK AREA CLEAN AND DRY. IF
SPILLS OCCUR, CLEAN IMMEDIATELY TO AVOID THE DANGER OF SLIPS
OR FALLS.
2.
To Turn Off Kettle.
a. Turn the thermostat dial to "OFF".
b. Press the ON/OFF switch to "OFF".
c. Before the unit is serviced, or if it will be off for a week or more:
(1) Set the thermostat and ON/OFF switch at "OFF".
(2) Turn the main gas cock OFF (handle at right angles to the gas pipe).
(3) Cut off electric power for the unit at the circuit breaker or fuse box.
3.
If Electric Power Fails
a. Do not attempt to operate the unit. The main burner cannot be lit until the power comes back
b. When power is restored, follow the instructions under "To Start Kettle" above.
4.
To Relight Kettle
Close the main supply gas cock, then follow the instructions under "To Start Kettle" above.
8
To Next Page
Loading...
Need help?
General
