OM-CC-G and C/2-G
20
WARNING
DO NOT SPRAY OR CLEAN THE DOOR WHILE
HOT. GLASS BREAKAGE MAY OCCUR IF THE
DOOR IS RAPIDLY COOLED WITH WATER.
f. Always check
the jumper cord
between the oven
front panel and
the door after
cleaning. Make
sure that it is
properly positioned
as shown to
prevent damage.
2. Interior CLEANING STEPS
For the (2)CC-10G and (2)C/2-20G double-stacked
units, the cleaning processes must be performed
on each cavity. When double-stack units are being
cleaned, wait five minutes after starting the first oven
clean cycle (Time/Status display will show CL:40)
before you start to clean the second cavity.
Clean Cooking
Chamber Only
De-Lime Steam
Generator Only
Clean Chamber and
De-Lime Generator
Omit step 3 Omit step 2
Perform all steps
in order
Before beginning this procedure, make sure the oven
HOT light is not on. If the HOT light is on, use the
FAST COOL instructions on page 18 to cool the
oven cavity.
WARNING
UNIT MAY BE HOT. DO NOT TOUCH HOT
SURFACES.
DO NOT PUT HANDS OR OTHER OBJECTS
INTO COOKING CHAMBER WHILE
CONVECTION COMBO™ IS OPERATING. THE
ROTATING FAN CAN BE HAZARDOUS.
STEP 1
After cooling the oven to 200ºF (90ºC) or less,
take the oven out of any mode in which it may
have been operating. (Wait at least two minutes,
or until the steam generator starts to fill, before
adding an deliming solution.) Enter 99 into the
timer. The Time/Status display will read
CC or CL.
WARNING
BEFORE REACHING INTO THE OVEN TO
REMOVE PARTITIONS, EXIT THE FAST COOL
MODE BY PRESSING ANY BUTTON OR BY
CLOSING AND REOPENING THE DOOR. DO
NOT REACH IN THE OVEN UNTIL THE FAN HAS
STOPPED MOVING.
OVEN MAY BE HOT — WEAR GLOVES OR USE
OVEN MITTS TO AVOID BURNS.
DO NOT OPERATE THE UNIT IN ANY MODE
UNLESS ALL FOUR REMOVABLE PARTITIONS
HAVE BEEN RETURNED TO THEIR PROPER
LOCATIONS.
STEP 2
Make sure to clean all food particles out of the
drain.
On a daily basis, follow the degreaser supplier’s
instructions, and apply degreaser to the entire
cooking cavity and pan racks.
Once a week, remove oven racks and partitions
in order. Use an oven mitt if the oven is hot. To
remove partitions:
Left
— The left partition includes a back
plate and an air distribution baffle. Lift up to
disengage the four hooks from their support
posts and remove the partition from the
chamber (see pictures on next page).
Right
— The right partition includes a large,
circular, flared opening that is centered in
front of the fan. Push upward to disengage
the four hooks from their support posts and
remove the partition from the chamber.
Bottom
— The bottom partition has a small
circular pattern of drain holes. Lift it directly
up and off from its four support posts.
To Next Page
Loading...
Need help?
General
