OM-CC-E
16
WARNING
WHEN YOU OPEN THE DOOR STAY AWAY
FROM ANY STEAM COMING OUT OF THE UNIT.
STEAM CAN CAUSE BURNS.
k.
When the timer reaches zero, it stops steam
generation and sounds a beeper alarm. Water in
the steam generator stays at its standby
temperature (200
o
F - 93
o
C). On some older
models, the beeper will continue to sound until
the door is opened or the CLEAR pad is
pressed.
l. Carefully open the door. If the food is
cooked, remove the pans using hot pads
or oven mitts to protect your hands from
the hot pans.
m. After the display has counted down to
zero opening the door or pressing
CLEAR once
will reset the display to the
time that was last used. Pressing
START will repeat the cook cycle. If the
same cooking time will be used
repeatedly, you only need to press the
number keys when you first use set that
time.
n. After the display has counted down to
zero you can reset the time to zero by
either (1) opening the door and pressing
CLEAR or pressing CLEAR twice. A
new cooking time may then be set by
using the number keys.
2. Oven Mode
a. To use the Convection Combo™ as a
convection oven, first switch on the
electric power by pushing the ON touch
pad. (If the SERVICE light comes on
when you turn on the power, see the
Troubleshooting section). If the door is
closed and the cooking temperature is
above 200
o
F (93
o
C) the fan will begin to
operate.
b. If the power is already on, and there is a
number in the time display window,
press the CLEAR touch pad one or more
times to reset the time to zero.
NOTE: You cannot change operating
modes while the timer is running
c. The unit will power up in the mode of
operation in which it was last used.
Because of this, the indicator light for
that mode will be lit. If the unit is not
already in the Oven Mode, press the
OVEN touch pad. The OVEN light will
come on and the oven fan will operate.
d. Use the Temperature Control Knob to
set the desired cooking temperature,
which will appear in the temperature
display window. Unless the cooking
chamber is already at or above the
selected temperature, the unit will begin
heating and the WAIT light will come on.
To Next Page
Loading...
Need help?
General
