OM-CC-E and C/2-E
13
Operation
WARNING
ANY POTENTIAL USER OF THE EQUIPMENT SHOULD BE TRAINED IN SAFE AND CORRECT OPERATING
PROCEDURES.
A. Controls and Indicators
Operator controls are on the right front side of the
unit. Their use is described below:
1. Time Section
In Oven and Combo Modes, the timer
functions only as a “cooking time minute
minder” and does not turn the unit on or off.
In the Steamer Mode, however, it controls the
steaming function.
a. Time/Status Display — Shows operating
time remaining in the Steamer, Oven or
Combo Mode. The timer counts down
. If
the unit is equipped with, and operating in
the optional Hold Mode, the timer will
count up alternating with the word “Hold,”
and will show the total accumulated time
that the product has been holding. The
display shows operating time in
“hours:minutes” format. For example,
entering 9 and 0 will result in a display of
01:30.
b. Number touch pads — used to enter time
values.
c. CLEAR — Pressing this touch pad once
stops the beeper and resets the timer to
the time that was last set. Pressing twice
clears it to 00:00. At the end of a cooking
period, opening the door is the same as
pressing CLEAR once.
d. START — Press this touch pad to start
the timer. If the unit is in Steamer Mode, it
will also cause steaming to begin.
2. Status Lights
a. HOT — Indicates cooking chamber
temperature is more than 15
o
F (8
o
C) over
the set temperature. (See Paragraph 5 in
this section)
b. SERVICE — Indicates that there is a
problem which might require a service
call. If there is such a problem, the
beeper will sound and the SERVICE light
will be on when you switch on the power.
The unit may continue to operate,
depending on the type of problem. Refer
to the Troubleshooting section to
determine the nature of the problem.
c. WAIT — Indicates the unit is either
heating or cooling toward the set
temperature. The HOT and WAIT lights
will both be on if the chamber is more
than 15
o
F (8
o
C) above the set point.
d. READY — Indicates the unit is ready for
use.
e. CLEAN —- Indicates the unit needs
cleaning. The unit will temporarily
operate if this light is flashing.
To Next Page
Loading...
Need help?
General
