What to do if the pilot lights, but the main burner will not come on, and spark does not stay on in Groen TDH Kettle?
If the pilot light ignites, but the main burner doesn't come on and the spark does not stay on in your Groen Kettle, check that the gas pressure meets the control manufacturer’s specifications. If the issue persists, replace the spark ignition module.
What to do if the pilot lights, but the main burner will not come on, and the spark stays on, in Groen TDH?
If the pilot light is on, but the main burner won't ignite and the spark remains on in your Groen Kettle, check these items: * Ensure the sensor cable is securely attached to terminal '1' on the module and to the sensor. * Inspect the sensor ceramic for cracks. * Confirm that the cable is not grounded out; correct any grounding issues. * Check the sensor cable for continuity and the condition of its insulation. * Verify the gas pressure. * Clean the pilot assembly. * Tighten all mechanical and electrical connections.
What to do if the safety valve pops on Groen TDH Kettle?
If the safety valve on your Groen Kettle pops, consider the following: * Check for air in the jacket. * Inspect the safety valve. If it pops at pressures below 49 PSIG, replace it. * Verify if the high limit pressure switch is set too high. * Examine the thermostat operation.
General| Type | Tilting Kettle |
|---|---|
| Material | 304 Stainless Steel |
| Jacket Type | Steam Jacketed |
| Controls | Manual or Touchscreen |
| Tilting Mechanism | Manual or Electric |
| Heating Method | Steam |
| Agitator Type | Optional |
| Temperature Control | Thermostatic |
| Applications | Soups, sauces, stews, pasta |
To Next Page
