Groov-e GV-DR02 - Page 8

Instructions(Cont.)
Adding a Station to Preset
Retrieving a Preset Station
1. Whilst in DAB or FM mode, tune into a station that you wish to add to you
preset.
2. Hold the PRESET button; select the preset number you wish to store the
station to, then press the TUNE/SELECT button
.
3. Rotate the TUNE/SELECT dial until you reach your desired preset
position. Prsse
the
TUNE/SELECT dial to set.
4.
The LCD will
display a confirmation message, such as 'Preset 1 Stored'
NOTE:
You can also quickly add a s tation to the 1,2, or 3 memory button By holding
the respective button down on the front of the radio until it states "Preset
Stored"
.
1. To retrieve a station from the 1, 2 or 3 memory button, press the respective
button on the front of the radio.
2. To retrieve a station from 4 to10, press the PRESET button, then rotate
The TUNE/SELECT dial until the desired station is shown. Press the
TUNE/SELECT dial to select the station.
Bluetooth Operation
1. Press the SOURCE button until BT mode is selected.
2. When Bluetooth mode is activated, it will commence pairing. Follow the
instructions on your Bluetooth enabled device to pair with GV-DR02
3. You can now play music through Bluetooth.
4. Use the VOLUME dial to adjust to your desired output level.
5. Rotate the TUNE/SELECT dial clockwise to go to the next song or anti-
clockwise to go to the previous song.
6. Press the TUNE/SELECT dial to Play/Pause the current song.