Installation
Unpacking and Inspection
Before opening outer package, check if there is any visible damage on the outer package, such as
holes,cracks or other signs of possible internal damage.
If there is any abnormality on the package or model of the energy storage is inconsistent, do not open it and
contact your distributor.
Check the following parts list to ensure it is complete:
Parallel communication cable
AC input/output connector
Note: The Software CD is no longer provided, if necessary, please download it from the official website
www.ginverter.com
Selection of Installation Location
Basic Requirements
When the energy storage is running, the temperature of the case and the radiator will be high. Therefore, do
not install them in a place that is easy to touch.
Do not install in areas where flammable and explosive materials are stored.
If the energy storage is installed in areas with salt damage, it will be corroded and may cause fire. Therefore,
do not install it outdoors in areas with salt damage. The areas with salt damage are defined as
the areas which are not 500m away from shore or will be affected by sea breezes. The areas affected by
the sea breezes vary depending on meteorological conditions (e.g. typhoons, monsoons) or topographical
conditions (dams, hills).
Do not install in the place where children can touch.
When handling any heavy objects, you should be prepared to bear loads to avoid being crushed or
sprained.
When handling the device by hand, wear protective gloves to avoid injury