6.3.2 USB port
In MAX-X series inverters, RS485 interface is standard. The connection steps of RS485
communication line are as follows:
1) Unscrew the waterproof cover of the COM interface and remove it.
2) Connect the RS485 communication line to the port of 485-1.
3) The inverter is connected hand in hand through the RS485 communication line, and
the end of the communication line 485_A/B is connected to the monitoring equipment to
realize multi-machine remote monitoring.
Note: When locking the RS485 cable screw, the torque is 4kgf·cm.
Fig 6.7
The MAX-X series inverters are equipped with a USB interface as standard, which can be
connected to a USB to WIFI module, Shine GPRS-X2, Shine WIFI-X, Shine 4G-X, Shine
Link-X and other optional monitoring modules to realize remote Monitoring function. In
addition, you can also quickly upgrade the inverter software through the U disk.
Steps to install the monitoring module:
1> Loosen the waterproof cover of the USB interface and remove it.
2> As shown in Figure 6.8A, insert the Shine GPRS-X2 module into the USB interface,
and the LED of the Shine GPRS-X2 module will be on.
3> As shown in Figure 6.8B, make sure that the △is facing upwards, insert the
monitoring module into the USB interface, and tighten the lock.
Note: If you use a USB to WIFI module, when the operator leaves, please take the module
and the data cable away, and tighten the waterproof cover to prevent water from
entering the interface.
Fig 6.8A
21
22
Fig 6.8B
The Inverter Side
The Inverter Side
The Inverter Side
The Inverter Side
up
Installation
Remove
To Next Page
Loading...
