Need help?Do you have a question about the Grundfos CIU 500 and is the answer not in the manual?
General| Brand | Grundfos |
|---|---|
| Model | CIU 500 |
| Category | Controller |
| Language | English |
Crucial safety warnings for operational hazards.
How to configure the data transmission speed for Modbus.
How to configure stop bits and parity for Modbus.
Procedure for selecting the unique Modbus slave address.
Procedure for configuring IP addresses for the CIM 500.
Steps to connect to the CIM 500 webserver.
Registers used for controlling booster system operations.
Explanation of different operational control modes.
How to set setpoints in closed-loop operation.
How to set setpoints in open-loop operation.
Codes and descriptions for system-wide alarms.
Codes and descriptions for pump-specific alarms.
Step-by-step guide for CIM 200 hardware installation.
Step-by-step guide for CIU 200 hardware installation.
Setup guide for CIM 260 cellular call-up connections.
Setup guide for CIU 260 cellular call-up connections.
Setup guide for CIM 260 cellular data connections.
Setup guide for CIU 260 cellular data connections.
Setup guide for CIM 500 Modbus TCP communication.
Setup guide for CIU 500 Modbus TCP communication.
Example of how to set a new setpoint value.
Troubleshooting guide for CIM/CIU 200 issues.
Troubleshooting guide for CIM/CIU 260 issues.
Troubleshooting guide for CIM/CIU 500 issues.
To Next Page
