Need help?Do you have a question about the Grundfos CIM 250 and is the answer not in the manual?
General| Brand | Grundfos |
|---|---|
| Model | CIM 250 |
| Category | Controller |
| Language | English |
Explains how to configure the Modbus transmission speed for CIM 200.
Details how to set parity and stop bits for CIM 200.
Describes how to set the unique Modbus slave address using rotary switches.
Explains the function and settings of the termination resistor.
Describes the status indications provided by the CIM 200 LEDs.
Details registers for CIM module configuration and their parameters.
Detailed register definitions for Pump 1 status and operation.
Step-by-step guide for hardware setup of the CIM 200 module.
Guide for hardware setup of CIM 250 for GSM call-up communication.
Guide for hardware setup of CIM 250 for GPRS communication.
Step-by-step guide for Modbus TCP communication setup for CIM 500.
Identifies faults based on the status of CIM 200 LEDs.
Lists common Modbus communication faults for CIM 200 and their remedies.
Identifies faults based on the status of CIM 250 LEDs.
Identifies faults based on the status of CIM 500 LEDs.
To Next Page
