Need help?Do you have a question about the Grundfos CIM 200 and is the answer not in the manual?
General| Type | Communication Interface Module |
|---|---|
| Communication Protocol | Modbus RTU |
| Power Supply | 24 V DC |
| Enclosure Class | IP20 |
| Housing Material | Plastic |
| Application | Connecting a Grundfos pump to a Modbus RTU network |
| Storage Temperature | -40°C to +70°C |
| Relative Humidity | Max. 95 % non-condensing |
Explains how to configure the communication speed for the CIM 200 Modbus RTU.
Details how to set the parity and stop bits for Modbus communication on the CIM 200.
Describes how to configure the IP address and subnet mask for the CIM 500.
Details registers for configuring the CIM module's behavior and settings.
Explains the SCADA PIN code protection mechanism and its Modbus interaction.
Lists and describes the various alarm and warning codes and their meanings.
Provides troubleshooting steps and possible causes for faults in the CIM 200 module.
Lists troubleshooting steps and possible causes for faults in the CIM 250 module.
Details troubleshooting steps and possible causes for faults in the CIM 500 module.
To Next Page
