22.10.2002
GB
10 of 12
10
Tighten the hexagon socket head screws two and two (one side at a time), see section 2. Torques and lub-
ricants.
Check that the gaps either side of the coupling halves are equal and check the pump by turning the coupling.
If the pump is tight or it cannot be rotated, a further adjustment should be carried out.
Fit the two coupling guards pos. 7 and fasten them with the screws pos. 7a.
The pump is now assembled. Check the head and flow and compare the results with the test specification
no. BM33A001.
To Next Page
Loading...
