Grundfos MGE 112 Series User Manual

English (GB)
24
Advanced control panel
"Settings" MGE
Multimotor
system
Section Page
""Setpoint"" ●●10.1 ""Setpoint"" 32
""Operating mode"" ●●10.2 ""Operating mode"" 32
""Set manual speed"" ●●10.3 ""Set manual speed"" 32
""Control mode"" ●●10.4 "Control mode" 32
""Analog inputs"" ●●
10.5 ""Analog inputs"" 32
""Analog input 1, setup"" ●●
""Analog input 2, setup"" ●●
""Analog input 3, setup""
1)
●●
""Pt100/1000 inputs""
1)
●●
10.6 ""Pt100/1000 inputs"" 33""Pt100/1000 input 1, setup"" ●●
""Pt100/1000 input 2, setup"" ●●
""Digital inputs"" ●●
10.7 "Digital inputs" 34""Digital input 1, setup"" ●●
""Digital input 2, setup""
1)
●●
""Digital inputs/outputs"" ●●
10.8 ""Digital inputs/outputs"" 35""Digital input/output 3, setup"" ●●
""Digital input/output 4, setup""
1)
●●
""Relay outputs"" ●●
10.9 "Signal relay" (""Relay
outputs"")
36""Relay output 1"" ●●
""Relay output 2"" ●●
""Analog output""
1)
●●
10.10 ""Analog output"" 36""Output signal"" ●●
""Function of analog output"" ●●
""Controller settings"" ●●
10.11 "Controller" (""Controller
settings"")
37
""Operating range"" ●●10.12 ""Operating range"" 37
""Setpoint influence"" ●●
""Ext. setpoint infl."" ●●10.13 ""External setpoint function"" 37
""Predefined setpoints""
1)
●●10.14 "Predefined setpoints" 40
""Monitoring functions"" ●●
""Motor bearing monitoring"" ●●10.20 ""Motor bearing monitoring"" 42
""Motor bearing maintenance"" ●●
"Bearings replaced" (""Motor
bearing maintenance"")
43
""Limit-exceeded function"" ●●10.15 ""Limit-exceeded function"" 41
1)
Only available if an advanced functional module, type FM 300, is fitted.
Continued on page 25.

Grundfos MGE 112 Series Specifications

General

Brand	Grundfos
Model	MGE 112 Series
Category	Engine
Language	English