Need help?Do you have a question about the Grundfos PM2 and is the answer not in the manual?
Explains dip switch settings to define pump start pressure levels.
Details the dip switch setting for stopping the pump at START + 1 bar.
Describes dip switch settings and operation for automatic pump reset.
Explains dip switch configurations for preventing frequent pump starts/stops.
Details dip switch settings for limiting maximum pump run time.
General| Supply Voltage | 220-240 V |
|---|---|
| Frequency | 50/60 Hz |
| Max. Current | 10 A |
| Enclosure Class | IP65 |
| Start Pressure | 1.5-5 bar |
| Max. Operating Pressure | 10 bar |
| Liquid Temperature | 0°C to +40°C |
| Power Consumption | 12 W |
| Storage Temperature | -10°C to +70°C |
| Relative Humidity | 95% RH |
| Protection Class | II |
To Next Page