Need help?Do you have a question about the Grundfos UP26-96F and is the answer not in the manual?
Specifies fluid temp, ambient temp, working pressure, and inlet pressure limits for UP15-42F/VS.
Specifies fluid temp, ambient temp, working pressure, and inlet pressure limits for UP26-96F/VS.
Connects current signal wires to control terminals Com(-) and Ret/I.
Connects voltage signal wires to control terminals Com(-) and Os/V.
Verify speed control signal wiring using a voltmeter.
Fine-tune input signals using the offset dial when dip switch D is ON.
Adjust speed manually using the % dial when dip switch D is OFF.
Explains Power ON (green) and % Out (yellow) indicator LED functions.
Circuit ratings for voltage speed control signals, terminals, and limits.
Circuit ratings for current speed control signals, terminals, and limits.
Specifies fluid temp, ambient temp, working pressure, and inlet pressure limits for UP15-42F/VS.
Specifies fluid temp, ambient temp, working pressure, and inlet pressure limits for UP26-96F/VS.
Connects current signal wires to control terminals Com(-) and Ret/I.
Connects voltage signal wires to control terminals Com(-) and Os/V.
Verify speed control signal wiring using a voltmeter.
Fine-tune input signals using the offset dial when dip switch D is ON.
Adjust speed manually using the % dial when dip switch D is OFF.
Explains Power ON (green) and % Out (yellow) indicator LED functions.
Circuit ratings for voltage speed control signals, terminals, and limits.
Circuit ratings for current speed control signals, terminals, and limits.
General| Model | UP26-96F |
|---|---|
| Voltage | 230 V |
| Frequency | 50 Hz |
| Connection Size | 1 inch |
| Operating Pressure | 10 bar |
| Housing Material | Cast Iron |
| Impeller Material | Noryl |
| Shaft Seal | Mechanical Seal |
| Motor Protection | Thermal overload protection |
| Max Ambient Temperature | +40°C |
To Next Page
