ENGLISH
13
ENGLISH
13
DPS 5200 HIFI LOUDSPEAKERS
_____________________________________________
Operating controls of the subwoofer
I O ON/OFF Switches the subwoofer on and off (on back of device).
When you switch it on, the operating indicator on the
subwoofer lights up red.
AUTO ON/OFF Switches the automatic activation of the subwoofer on
and off (on back of device).
»ON«: The subwoofer switches on automatically when
it receives audio signals. If it does not receive any audio
signals, it switches off automatically after 5 to 6 minu-
tes.
PHASE 0° 180° Phase switch (on back of device).
VOLUME Adjusts the volume (on back of device).
AUDIO INPUT Audio signal input (on back of device).
230V~50/60 Hz Mains cable (on back of device).
Operating indicator (on front of device). Lights up red
when the subwoofer is switched on, and green during
operation.
Setting the subwoofer
When the system is connected, the volume of the subwoofer must be adjusted to
that of the other loudspeakers. The subwoofer must be switched off.
1 Turn the »VOLUME« knob of the subwoofer to the middle.
2 Switch on all the other system components.
3 Switch on the subwoofer with »I O ON/OFF«.
4 Set the receiver – in tuner mode, for example – to the desired volume level.
5 Adjust the volume of the subwoofer step by step to match the volume of the
other loudspeakers.
6 If necessary, switch over the phase with »PHASE 0° 180°«.
Note:
The phase is usually determined by the amplifier. Depending on the position
of the subwoofer and the distance to the listener, switching over the phase
can improve the quality of the bass playback.
To Next Page
Loading...
