12 ENGLISH
OPERATION _______________________________
Preparation
Caution:
■ Using for the first time: Boil water without
adding coffee for at least 4 times.
■ Please follow the steps at the “operation”
section from 1 – 2 and 5 – 12.
1 Remove all packaging and sticker materials
and dispose of them according to the
applicable legal regulation.
2 Before using of the appliance for first time,
clean all parts which come into contact with
water carefully.
(See the “Cleaning and care” section).
3 Make sure that the appliance is sitting in an
upright position and on a stable, flat, clean,
dry and non-slip surface.
Operation
1 Open water tank cover
C
and fill the water
tank
G
min. 3 – up to the MAX marking on
water level display
F
.
Note
■ Use only clean, cold and fresh drinking water.
2 Close water tank cover
C
.
3 Open swivel filter holder
E
by swinging the
filter holder handle
D
out to the left
4 Fill the desired amount of ground coffee up
to the MAX marking of the permanent filter
A
. To do this, you may use the supplied
coffee measuring spoon
O
Note
■ As an alternative to the permanent filter
A
, a
suitable paper filter may also be used, which
can be inserted right into the swivel filter
holder
E
.
5 Close the screw-on lid
H
of the thermal jug
L
. The arrow of the screw-on lid
H
must
be across from the arrow marking
I
for
“closed” on the thermal jug handle
K
.
6 Place the thermal jug
L
on the support for
thermal jug
M
.
7 Connect the plug into the wall socket
8 To turn the appliance on, press the On/Off
switch
N
to the “I” position, in order to turn
it on.
– On/Off switch
N
indicator light illuminates
and brewing process begins.
Note
■ The brewing process can be stopped at any
time by pressing On/Off switch
N
to “O”
position.
■ The appliance is equipped with a drip-stop
B
located underneath the swivel filter holder
E
and enables you to briefly remove the thermal
jug
L
to pour coffee before the water has
finished running through the machine.
Caution
■ However make sure to place the thermal jug
L
on the support for thermal jug
M
within a
very short time (max. 30 seconds). Otherwise
the coffee liquid from the filter could overflow.
9 Remove thermal jug
L
from the support
for thermal jug
M
, as soon as the brewing
process has finished and thermal jug
L
is
filled.
10 To pour coffee, turn the screw-on lid
H
counter clockwise, until the arrow on the
screw-on lid
H
is located across from the
arrow marking
J
for “open”.
Note
■ You can keep coffee hot in the thermal jug
L
,
for up to 1 hour approximately.
11 To turn the appliance off, press the On/Off
switch
N
to the “O” position.
– On/Off switch
N
indicator light and
appliance turns off.
12 Disconnect the appliance from the wall
socket.
Note
■ If you want to continue the brewing process,
repeat the procedure from 1 to 12. Let the
appliance cool down between each brewing
process.
Hints and Tips
■ Use softened or filtered water to prevent lime
build-up.
To Next Page
Loading...
