What to do if my GSE 675 Scales show 'CoDE08 Check Conn'?
The 'CoDE08 Check Conn' error on your GSE Scales means the signal into the A/D is significantly greater than expected. This usually points to a defective or incorrectly wired load cell.
Why do my GSE 675 display 'CoDE03 Over- Load!'?
The 'CoDE03 Over- Load!' error on your GSE Scales indicates that the input signal is greater than the positive full scale. Check for issues similar to those you would investigate for an underload situation.
What to do if my GSE 675 Scales display '#> Dsply'?
If your GSE Scales display '#> Dsply', either clear the totals or settle for only being able to transmit the totals.
What does 'Outof Range' mean on GSE 675?
The 'Outof Range' message on your GSE Scales indicates that an entry made for a selection was beyond the range of valid choices.
How to resolve 'Tare< 0!' error on GSE 675?
The 'Tare< 0!' error on GSE Scales means the GROSS Weight must be greater than zero unless P162 is changed to allow negative tares. For auto-tares, change P162 to allow negative tares.
What does No Start mean on GSE Scales?
To Next Page
General