GSW EASY CLICK - Troubleshooting Common Errors

26
8. How to Solve Errors
Warning!
As soon as uncontrolled steam
emerges, remove the source of heat.
The device is not to be used again until
the error has been corrected. Only a slight
emergence of steam from pressure regulator 8 is
normal.
Error Cause Solution
Steam is escaping from
between the lid and the base
Appliance not closed correctly Close the appliance again
correctly
Sealing ring is dirty Clean the sealing ring
Sealing ring is broken/worn away Replace the sealing ring (1 x year)
No steam is coming from the
pressure regulator
Steam is escaping from between
the lid and the base
See previous error
Pressure regulator is dirty Clean the pressure regulator (see
"7.2 Cleaning the pressure cooker"
on page 24)
Not enough liquid in the
appliance
Slowly cool down the appliance
and fill with at least 0.25 l liquid
Heat supply too low Increase the heat supply (turn the
hob to a higher setting)
Too much steam is coming
from the pressure regulator
Heat supply too high Decrease the heat supply (turn the
hob to a lower setting)
Pressure regulator is dirty Clean the pressure regulator (see
"7.2 Cleaning the pressure cooker"
on page 24)
Steam is escaping laterally
from the pressure regulator
The pressure regulator is not
correctly fitted
Fit the pressure regulator correctly
and tighten the union nut on the
inside of the lid using the key 12.
Steam is escaping from the
safety opening
The protective caps in the pressure
regulator are defective or not
properly fitted
Check the safety caps (see
"Pressure regulator (8)" on
page24)
The pressure regulator is soiled Clean the pressure regulator (see
"Pressure regulator (8)" on
page24)
The pressure regulator is defective Exchange the pressure regulator
for a new one
The lid does not open There is too much pressure in the
appliance
Follow the instructions in
"6.4 Opening the pressure cooker"
on page 22
DKT EasyClick DE-GB-FR Seite 26 Mittwoch, 27. Juni 2012 5:36 17