STEP 4
CONTINUED
SETUP STEP 1 STEP 2 STEP 3 STEP 4 CONGRATS!
5. Using the provided torque wrench, first select the
correct bit and install it into the wrench. Look for the
torque specification markings located on the front and
back of the stem, as well as on the seatpost.
If these markings are absent, torque all stem and
seatpost bolts to 7 Nm.
6. Use the included Allen key to tighten the cable guides.
7. Use the included zip ties to attach the brake and shifter
cables to the frame on either side.
1
5
6
7
To Next Page
Loading...
