CONGRATULATONS!
YOUR NEW GT BIKE IS
NOW ASSEMBLED
Before you ride, it’s important to perform a few pre-ride checks.
1. Your front reflector should be pointing straight ahead, perpendicular to the
ground. The rear reflector must be pointing straight back. Ensure that the
wheel reflectors are snug, by pulling them out slightly.
2. Secure the front wheel between your legs and twist the handlebars. If the
handlebars and the front wheel move independently, your stem fixing bolts at
the fork steerer are not tight enough.
3. Push down on the handlebar; it shouldn’t move. If it rotates forward or
backward, tighten the stem faceplate bolts.
1
1
3
2
SETUP STEP 1 STEP 2 STEP 3 STEP 4 CONGRATS!
To Next Page
Loading...
