14
Fury Owner’s Manual Supplement
Technical Information
Pivot Axles
192927 Rev 0 (11/23)
Pivot Axles
To remove pivot axles:
1. Unthread and remove idler, idler bolt , and spacer if present (only on main pivot).
2. Using an M6 bolt of threaded length > 30mm, thread the bolt through the exposed wedge
thread. Continue until the wedge is loosened.
3. Remove M6 bolt from main axle and remove wedge from M6 bolt.
4. Using 6mm Hex, unthread and remove main axle.
To install the pivot axles:
1. Disassemble and clean all parts of the pivot axle.
Inspect the parts for damage (e.g., burrs, scratches, deformity, wear). Replace the entire
pivot axle with a new one if necessary.
2. Apply a light coating of a high-quality bicycle bearing grease to the pivot axle surfaces,
axle and screw threads, and the wedge.
3. Align the linkage system and insert the threaded end of the pivot axle from the non-drive
side.
4. From the non-drive side, tighten the inserted pivot axle to 5 Nm using a 6mm hex key
fitted to a torque wrench.
5. Insert the small end of the wedge into the non-drive side pivot axle head.
6. Thread the screw through the wedge and tighten to 5.0 Nm.
Please Note: The idler gear assembly is fixed to the drive-side end of the main pivot axle.
The idler assembly must be removed first when installing the main pivot axle and last after
install the main pivot axle.
To Next Page
Loading...
