STEP 3
INSTALL THE
FRONT WHEEL
1
4
5
6
SETUP STEP 1 STEP 2 STEP 3 STEP 4 CONGRATS!
4. Roll the tire into the fork and set the fork dropouts
down onto the axle. Ensure the quick-release lever is
on the left-hand side of the bike.
5. If it’s too loose, open the quick release lever back up,
tighten the adjusting nut more and then close the quick
release lever again. Make sure the quick-release lever
is below and behind the fork.
6. Re-attach the brakes by squeezing them together, then
sliding the cable back into place.
Give the brakes a quick check, then slide the rubber
protector back into place.
To Next Page
Loading...
