How to fix a Gtec ZY120 UPS when it warns 'Battery not connected'?
If your Gtec UPS displays a 'Battery not connected' warning, it indicates the battery is not properly connected. Check if the battery switch is turned off or if the battery cables are disconnected. Ensure that the battery switch is on and the cables are securely connected.
What to do if my Gtec UPS warns about reversed line neutral wires or that PE is not grounded?
If your Gtec UPS warns about reversed line neutral wires or that the PE is not grounded, it means there is an issue with the wiring. Check the polarity of the line wire and neutral wire. Also, check if the PE on the input plug is shorted with the UPS rear panel. If not, please check PE wire in input power socket.
What does it mean when my Gtec UPS says 'Bypass Over Load'?
A 'Bypass Over Load' warning on your Gtec UPS indicates that the load is on bypass and is experiencing an overload. To resolve this, remove some loads to ensure that the total load is less than 95% of the rated capacity of the UPS.
What should I do if my Gtec UPS displays 'Bypass overload timeout'?
If your Gtec UPS shows a 'Bypass overload timeout' message, it indicates that the load on bypass is experiencing an overload for too long. To fix this, remove some loads and restart the UPS. Once the UPS is working normally, turn on the loads one by one.
How to activate EPO on Gtec ZY120 UPS?
To activate the Emergency Power Off (EPO) function on your Gtec UPS, short the EPO terminal 1&2.
Explains surge protection and filtering capabilities of the UPS components.
Details the PFC circuit's function in converting AC to regulated DC power.
Describes the inverter's role in converting DC to AC output power.
Explains how the battery charger maintains battery charge.
Details the different models covered by the manual.
Provides general specifications like power rating, input/output voltage, and battery parameters.
Steps for unpacking the UPS and checking package contents and condition.
Essential notes for safe and proper UPS installation, including ventilation and protection.
Details on connecting input power, output cables, and specific input protection requirements.
Details on turning the UPS on/off in normal and battery modes.
Basic maintenance requirements for the UPS batteries to ensure longevity.
Guidelines for monitoring the UPS operation status and identifying potential issues.
Procedures for setting the UPS's rated voltage and frequency parameters.
General| Capacity | 1200VA/720W |
|---|---|
| Input Frequency | 50/60Hz ± 5Hz |
| Output Voltage | 220/230/240VAC |
| Waveform | Simulated Sine Wave |
| Output Frequency | 50/60Hz |
| Transfer Time | 4-8ms |
| Battery Recharge Time | 4-6 hours to 90% capacity |
| Communication Interface | USB |
To Next Page
