Gtech Multi Mk.2 - Emptying the Bin; Cleaning the Filter

There’s no latch, the bin just pulls off.
It’s easier if you wiggle it as you pull it.
Remove the lter by pulling it from the top
of the bin. Tap the dirt from the lter and tip
any dirt from the lter housing. Wash the
lter if necessary.
Hold the Multi’s bin over a rubbish bin and
release the latch to empty the dirt. A gentle
tap will help. Remove the lter and tap off the
excess debris each time you empty the bin.
Wash the lter under a tap, squeeze it out
then let it dry completely before using it.
Recommended water temp 40ºC do not
use any detergent. (You can buy more at
www.gtech.co.uk)
Never put the bin back without
the lter inside. You could damage
the motor.
Cleaning the lter
Emptying the bin