QX System Installation Manual – Issue C
- 5 -
Getting Started
In this manual you will learn how to;
• Identify the components of the QX system
• Connect components together
• Make simple configuration changes
If you are new to the QX system it is recommended that you connect a basic system “on the bench”
and familiarise yourself with programming the panel. Before getting started ensure you have the
following components;
• A QX control panel
• A XiB LCD keypad
• A few meters of 4 core cable
Now follow these simple steps:
• Connect +, -, A and B terminals of the keypad (CN6-XiB) to the panel XiB bus connector
which is labelled “+ 1 A B” using a length of 4 core cable. For simplicity of wiring adhere to
the following colour coding;
+ Red
- Black
A Yellow
B Blue
• Connect the mains cable to the fused terminal block and apply power.
The keypad address must be set before it can be used on the system. To set the keypad
address, open the case so that the case tamper switch is activated. Press and hold the ? button until
the address prompt is displayed (approximately 4 seconds):
Address = ??
9 or
If the keypad has not been addressed then the prompt will be ?? or 99.
Press to exit address mode.
Address = 01
Press 01 to set the keypad address to 1, then press
9
to confirm
9 or
00:00 Sat 02 Jan
The keypad will then display the time/date and company name.
Guardall
PX KP Type-n
Version 1.00
If the displayed message is as shown, or no bleep is heard, then the
keypad is not responding so check the bus connections.
The keypad types are:
Description Type
Standard or with proximity reader 1
With 2 EOL circuit inputs 2
Once the keypad is replying then enter the default engineer PIN code, 9999, remembering to
terminate the PIN code by pressing 9.
00:00 Sat 02 Jan
Enter-****
The PIN code digits are displayed as “*” characters.
To Next Page