SET UP
1. Select a firm, level and flat location for the air purifier. For proper air flow, locate the unit at
least 1 foot from any wall or furniture. Make sure none of the grills are blocked.
2. Carefully remove your air purifier from box and bag.
3. Determine preferred position of purifier based on space and preference.
E-6 E-7
Vertical Position Horizontal Position
DIRECTIONS FOR USE
Power & Variable
Speed Control
Figure 2
OPERATING THE AIR PURIFIER
1. Plug the power cord into a 120V AC outlet.
2. Turn unit power ON.
3. Select fan speed MODE 1 - 3
(I = lowest speed setting;
III = highest speed setting)
4. Select UV-C ON or OFF using
UV-C Power Button (Figure 2).
I
I
I
I
I
I
UV-C Control
4. Adhere 4 felt pads to unit base to protect table top surface. Remove adhesive backing and apply
one pad to each corner of unit base depending on preferred position in Step 3 (Figure 1).
GENERAL CLEANING
Always unplug the unit before cleaning or servicing in any way.
Caution: Do NOT use gasoline, benzine, thinner, harsh cleaners, etc. on and/or in the unit
while cleaning as they will damage the product. NEVER use alcohol or other solvents.
Note: Do NOT stick any foreign objects or your fingers inside the unit.
1. Wipe the surface of the unit with a clean, dry soft cloth as needed.
2. Clean the Filters monthly with the brush of your vacuum cleaner.
3. Remove and Clean (or Replace) Filters.
CLEANING & MAINTENANCE
a. Lift and remove the Rear Cover
from the unit.
b. Remove Pre-filter/Charcoal layer from tabs
on Rear Cover of unit.
c. Remove HEPA filter from unit. d. Clean both filters with the brush attachment of
your vacuum cleaner to remove lint and dust.
IMPORTANT: Do NOT try to wash and re-use
the filters.
IMPORTANT: Do NOT try to wash and re-use the filters. Please contact Customer Service
at 1.866.603.5900 or visit us at www.guardiantechnologies.com to purchase
replacement filters.
Replacement Filters: Filters E (FLT4100)
Figure 1
To Next Page
Loading...
Need help?
General
