X１
X１
Manual Setting
Setting the Force Manually (FOR INSTALLERS ONLY)
STEP1.
Press “FORCE” button. Up LED is on. You are now in
“FORCE UP” setting mode.
To enter “FORCE DOWN” setting mode press “FORCE”
again within 5 seconds.
STEP2.
To change the force setting. To increase or decrease one
increment press up or down button once. A beep sound
indicates increase or decrease each increment.
Note:
The maximum force is at six increment. When the
maximum increment has been reached, Up LED blinks
and beeps twice. The minimum force is at 0. When the
minimum increment has been reached, down LED blinks
and beeps twice, it is now at 0 increment.
>=6
X2
<=6
X2
STEP3.
To complete “FORCE UP” setting mode. Press “FORCE”
button. Up LED goes off. “OK” LED flashes once and goes
off. “FORCE UP “setting is completed
17
To complete “FORCE DOWN” setting mode. Press
“FORCE” button. Down LED goes off. “OK” LED flashes
once and goes off. “FORCE DOWN “setting is completed
To Next Page
Loading...
