E-8 E-9
DIRECTIONS FOR USE
If scale becomes difficult to remove with brush:
1.FilltheBasewith:mixtureof1tsp.whitevinegarand1tsp.water.
2. Let solution stand for 5 minutes.
3.WiththevinegarintheBase,cleanallinteriorsurfaceswithasoftclothorbrushtohelp
remove scale.
4.Alsocheckmistnozzleandmisttubeinwatertank.Cleanasneeded.
5.RinsetheBasethoroughlywithwatertoremovescaleandvinegarsolution.
END OF SEASON STORAGE
•FollowtheCleaningandDescalinginstructionswhenthehumidierwillbestoredattheend
of the season.
•Drythehumidiercompletelybeforestoring.DONOTstorewithwaterinsidetheBaseor
Water Tank.
•Pack the unit in its original carton and store in a cool, dry location.
NOTE: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR
HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE
TO THE HUMIDIFIER OR PERSONAL INJURY.
PROBLEM SOLUTION
Watervapor&humidityarenot
produced.
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Tank Installation: Make sure the tank is correctly attached.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(seepg.E-7)
Air blows but water vapor is not
produced.
ExcessiveWater:Removeacertainamountofwaterfrom
the tank.
The desired humidity is lower than the current temperature:
Increase the desired humidity.
Detergent
residueand/oroilingredientsfromcosmetics, etc may
beintank;washouttankandtryagain.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(seepg.E-7)
If you use hard water, replace with softer water.
Humidity level is low. The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see
pg.E-7)
The water in the unit is too cold: Replace with cool, but not
cold water.
Damageontheultrasonicdisk:ContactCustomerService
1.866.603.5900
The humidity has a bad smell. Poor maintenance or dirty water: Clean the product thoroughly
, and
llitwithfreshwater.(seepg.E-7)
White dust is forming on
nearby furniture.
Hardwatermaydepositacertainamountofdust.Dustintheair
also settles because of added humidity in the room. Use distilled
water if this becomes a nuisance.
Light on front of unit is red.
Unit has stopped working.
No or low water. Unplug unit and refill tank.
Water is accumulating outside of unit
or area surrounding unit.
Saturation of humidity. Lower mist control setting.
Unit not level and water is accumulating. Unplug and place on
level surface. Point spray away from objects. Raise unit on a
water-resistant
levelsurface2-3feetoffofoor.
Increased noise level. Unit
mustbeplacedonaat,level,hardsurface.Makesureitis
NOT placed on a soft or absorbent surface.
TROUBLESHOOTING GUIDE