EasyManua.ls Logo

Gude Basic 8T/DTS - User Manual

Gude Basic 8T/DTS
57 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Basic 8T/DTS
#02030
© Güde GmbH & Co. KG - Birkichstrasse 6 - D-74549 Wolpertshausen - Deutschland
Deutsch D - 4
Originalbetriebsanleitung
HOLZSPALTER
English GB - 11
Translation of original operating instructions
WOOD SPLITTER
Français F - 18
Traduction du mode d’emploi d’origine
FENDEUSE DE BÛCHES
Čeština CZ - 25
Překlad originálního návodu k provozu
ŠTÍPAČ ŠPALKŮ
Slovenčina SK - 31
Preklad originálneho návodu na prevádzku
ŠTIEPAČKA KLÁTOV
Nederlands NL - 37
Vertaling van de originele gebruiksaanwijzing
HOUTSPLIJTER
Italiano I - 44
Traduzione del Manuale d’Uso originale
SPACCATRICE DEI TRONCHI
Magyar H - 51
Az eredeti használati utasítás fordítása
RÖNKHAÍÓ

Questions and Answers

  • A
    Amy GreerJul 28, 2025
    How to troubleshoot a Gude Basic 8T/DTS Log Splitter engine that is not starting?
    • T
      tammy66Jul 28, 2025
      If the engine of your Gude Log Splitter isn't starting, check the following: First, ensure there is current in the outlet by checking the network protection. Second, inspect the extension cable for defects and replace if necessary. Third, make sure the feeder cable is correctly connected with 5 cores with a cross section of 2.5 mm2. Fourth, if the switch or condenser is defective, have the appliance checked by an electrician.
  • K
    Kurt SchmidtAug 7, 2025
    Why is the hydraulic pump whistling and splitting knife running jerky on my Gude Log Splitter?
    • M
      Mikayla DavisAug 7, 2025
      If the hydraulic pump of your Gude Log Splitter is whistling and the splitting knife is running jerky, first, tighten the screwing and replace the hoses if there is oil loss or the surface is dirty. Second, add hydraulic oil if there is too little in the tank.
  • T
    Thomas SweeneyAug 17, 2025
    Why is my Gude Log Splitter engine running in the wrong direction?
    • J
      Joshua DouglasAug 17, 2025
      If the engine of your Gude Log Splitter is running in the wrong direction, turn the phase changer in the appliance plug using a screwdriver to correct the connection.

Summary

Technical Specifications

General Safety Instructions

Electric Connection

Defective Feeder Cables

Identifies causes of feeder cable damage and risks associated with them.

400 V; 50 Hz Three-Phase Engine

Operation and Transport

Operation

Step-by-step guide on how to operate the wood splitter safely.

Appliance-Specific Safety Instructions

Mechanical Residual Risks

Risks related to jamming, amputation, and injury from falling wood.

Getting Caught, Winding-up

Risks of loose clothing or hair getting caught by rotating parts.

Electrical Residual Risks

Risks associated with direct and indirect electrical contact.

Exposure to Noise

Neglecting Ergonomic Principles

Other Risks

Emergency Procedures

Inspections and Servicing

Safety Instructions for Inspections and Servicing

Safety precautions to be followed during inspections and servicing.

Splitting Knife

Recommendations for maintaining the splitting knife for optimal performance.

Two-Hand Protective Equipment

Advice on maintaining the combined holding and clamping equipment.

Splitting Post

Movable Parts

Hydraulic Equipment

Checking the Hydraulic Oil Level

Procedure for checking the hydraulic oil level when the appliance is cold.

Change the Oil Once a Year

Annual maintenance procedure for changing the hydraulic oil.

Checking the Appliance Whether It Is Working Properly

Functional checks to be performed before each use of the appliance.

Troubleshooting

Engine Not Starting

Wrong Engine Running Direction

Splitting Knife Not Moving

Splitter Has No Power

Green Switching Button Not Staying in Place

Hydraulic Pump Whistling; Splitting Knife Running Jerky

Gude Basic 8T/DTS Specifications

General IconGeneral
ModelBasic 8T/DTS
Voltage400 V
Frequency50 Hz
Weight144 kg
Splitting Force8 t

Related product manuals