Gude TK 2500 - Technical Data

31
TK 2500 English
Read and understand the operating instructions
before using the appliance. Abide by all the safety
measures stated in the service manual. Act responsib-
ly toward third parties.
In case of any doubts about connection and operati-
on refer please to our customer center
Specied Conditions Of Use
The circular saw is only intended to cut wood and
wood like products.
Do not use this product in any other way as stated for
normal use.
Not observing general regulations in force and
instructions from this manual does not make the
manufacturer liable for damages.
Requirements for operating sta
The operating sta must carefully read the Opera-
tingInstructions before using the appliance.
Because wrong using of the appliance can be risky,
only competent persons are allowed to operated it.
Operator must be trained properly concerning adjust-
ment, operation and appliance using.
Qualication:: Apart from the detailed instructions
by aprofessional, no special qualication is necessary
forappliance using.
Minimum age:: Persons over 18 years of age can
only workon the appliance.An exception includes
youngsters trained in order to reachknowledge
under supervision of the trainer duringoccupational
education.
Technical Data
2)
The values stated are emission values and as such do not necessarily constitute values which are safe for the
workplace. Al- though there is a correlation between emission levels and environmental impact levels, whether
further precautions are neces- sary cannot be derived from this. Factors inuencing the actually present environ-
mental impact level in the workplace include the characteristics of the work area and other noise sources, i.e. the
number of machines and other neighbouring work process- es. The permitted workplace values can likewise vary
from country to country. This information is intended to assist the user in estimating hazards and risks.
Theappliance meets EN 61000-3-11 requirements and is subject to specialconnection conditions. That means
that use on optionally selectedconnection points is inadmissible. Theappliance can lead to occasional voltage
uctuations underunfavourable power conditions. Theappliance is only designated to be used for connection
points notexceeding the maximum allowed impedance of Zmax=0,233 . Asa user, you must make sure your
connection point on which you wantto use the appliance meets the above-mentioned requirements –after
agreement with your electricity supplier ifnecessary.
GB
Circular table saw ..................................................................................................................................... TK 2500
Art. No ....................................................................................................................................................................................................55187
Service connection ...................................................................................................................................................230 V/ 50 Hz
Rated input ............................................................................................................................................................................2200 W
Idle speed ........................................................................................................................................................................4700 min
-1
Saw blade dia. x hole dia ...................................................................................................................................... 250 x 30 mm, HM 36 Z
Cutting depth max. 90° ......................................................................................................................................................74 mm
Cutting depth max. 45° ......................................................................................................................................................63 mm
Weight .........................................................................................................................................................................................20 kg
Dimensions LxWxH (in mm) ................................................................................................................900 x 690 x 1035 mm
Noise and Vibration Information
Sound pressure level L
pA
1), 2)
....................................................................................................................................................94,8 dB (A)
Guaranteed sound power level L
WA
2)
................................................................................................................................ 107,8 dB (A)
Wear ear protectors!
1)
Measured according to EN ISO 11202:1995/AC:1997,
under load, Uncertainty K=3 dB (A)