17
Maintenance
3. REPLACING THE CARBON BRUSHES
Check the carbon brushes regularly. If the carbon brushes are worn down to about
4mm, replace them with the new set (not supplied). It must be replaced in pairs.
With a suitable slotted screwdriver turn the cap anti-clockwise until the carbon brush is
released, replace the brush and make sure that they locate well and are secured within
the brush retainer.
4. MOVING THE SAW
1) When transporting the saw with fixed locations, make sure that the saw head is
locked in the lower position.
2) The rotary table locking knob, the bevel lock lever and the slide rod securing knob,
must all be securely tightened.
3) Use the transportation handle to lift the saw. Do not lift the saw by the switch handle.
To Next Page
Loading...
