13
Rated voltage 230-240V~50Hz
Power 300W
Oscillations speed 11000-20000/min
Oscillations angle 3.2°
Protection class
/II
Tool weight 2kg
A weighted sound pressure L
pA
: 79.5dB(A)
A weighted sound power L
wA
: 90.5dB(A)
K
pA
& K
wA
=3.0dB(A)
Wear ear protection when sound pressure is over 80 dB (A)
Noise Information
Vibration Information
Vibration total values (triax vector sum) determined according to EN 62841:
Typical weighted
vibration
Vibration emission value a
h
= 3.905m/s
2
Uncertainty K =1.5m/s²
The declared vibration total value and the declared noise emission value have been
measured in accordance with a standard test method and may be used for comparing
one tool with another.
The declared vibration total value and the declared noise emission value may also be
used in a preliminary assessment of exposure.
WARNING: The vibration and noise emissions during actual use of the power
tool can differ from the declared value depending on the ways in which the tool
is used especially what kind of workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration and noise accessories
are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions
of use should also take account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but not actually doing the job.
This may significantly reduce the exposure level over the total working period.
Technical Data
Technical Data Table
To Next Page
Loading...
