8
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The power tool is intended for sawing and remodelling wooden materials, plastic, plaster, non-ferrous
metals and fasteners (e.g. nails and clamps) as well as for working on soft wall tiles and for dry
grinding of small surfaces. It is especially suitable for working close to edges and for flush cutting.
1. ASSEMBLE ACCESSORIES
CAUTION: For all work or when assembling accessories, always wear protective
gloves. Avoid risk of injury from the sharp edges of the accessories. Accessories
can become very hot while working, presenting danger of burns! Make sure the tool is
unplugged prior to assembling accessories.
WARNING: To reduce the risk of injury, do not let the sharp side of the accessory
face back toward the user’s hand.
Flip the tool- free blade change lever
(
1
)
forward to the open position and take off the
flange(6) from the machine. (SEE FIG. A)
Insert the accessory onto the blade interface
(
6
)
, Make sure/ ensure the accessory is on the
right position of the blade interface
(
6
)
. ( SEE EXAMPLE FIG. B1 B2 )
Operating Instructions
B1
B2
To Next Page
Loading...
