6
Safety Information
Important - Please read these instructions fully before starting assembly
Safety instruction for cutting
1. Hold power tool by insulated gripping surfaces, when performing an operation where
the cutting accessory may contact hidden wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
2. Additional safety rules:
1) Always wear eye protection.
2) Always wear ear protection during extended periods of operation.
3) Always inspect and remove all nails and screws etc before sanding.
4) Always check walls and ceilings to avoid hidden power cables and pipes. A metal
detector can be obtained from any good DIY store for this purpose.
5) Use the original accessories and the tool provided, no others.
6) Only use accessories in good condition. Do not use torn or worn accessories.
7) Do not turn the machine on whilst any of the accessories are resting on or inserted into
the work piece or material that you want to work with. Wait until the machine is up to
full speed before proceeding with your task.
8) Keep your hands away from cutting area. Do not reach under the material being cut.
9) The operating instructions and the enclosed safety information should be kept carefully
for later use and enclosed with the machine, should it be passed on or sold.
Safety warning for LED lamp
WARNING: The LED lamp equipped with power tool is in excess of the Exempt Group.
In order to avoid the viewer-related risk, operator shall be more careful and read all
safety warnings and all instructions. Failure to follow the warnings and instructions
may result in optical injuries.
To Next Page
Loading...
