Guild PRG500G - Intended Use and Material Preparation

Customer Helpline 0333 3201989
7
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The spray gun is for spraying non-flammable and non-hazardous paints and varnishes
suitable. The tool could not be used for spraying of flammable liquids. Do not use the tool
for the food, pharmacy or other purposes that are not mentioned in the manual.
1. COATING MATERIALS
Solvent-based and water-based paints, finishes, primers, two-component paints,
varnishes, automotive topcoats, stains and wood preservatives.
2. UNSUITABLE COATING MATERIALS
Wall colors (dispersion), etc., alkali and acidic paints.
3. PREPAREDNESS THE COATING MATERIAL
Measuring the viscosity using the viscosity cup. (See Fig. A)
1) Stir well coating material before the start of the measurement.
2) Fill the viscosity cup with coating material (100 cm3).
3) Lift viscosity cup and measure the time in seconds, until the coating material finish
dripping.
4) These are called run-DIN-seconds (DIN-s)
Coating material viscosity DIN-s
Solvent-based paints-------------------------------15-50
Primers--------------------------------------------25-50
Pickling----------------------------------------undiluted
2 Combination paints-------------------------------20-50
Varnishes------------------------------------------15-40
Waterborne paints---------------------------------20-40
Automotive topcoats-------------------------------20-40
Wood protection center l ----------------------undiluted
Operating Instructions
A
�╚└� 25.400