18
5. Checking the mechanical state of the hoist
• Clean the hoist to remove dirt and other impurities
• Inspect and evaluate vital components
• Replace defective and worn components
• Check and tighten all moving parts
• Lubricate the hoist
• Where applicable, treat the surface with silicone oil
6. Replace cover/screen
7. Go through the checkpoints under item 2 again to make sure that
everything functions
8. Have new problems arisen or been found under item 7?
• If new problems have arisen, return to item 3
• If there are no new problems, the inspection is completed
9. When a service inspection including service work or exchange of
components has taken place, the nal check must comprise a weight
test with the product’s nominal load.
5.03 Troubleshooting
Does the GH2 hoist fail to respond when buttons on the hand control
are pressed?
• Check that the emergency stop has not been activated
• Check that power is supplied to the hoist
• Contact the Guldmann Service Team
The hand control may be defective
Does the green lamp on the hoist blink when the batteries are
recharging?
• Check that the yellow charging indicator lights up when the hoist is put in the
recharging position
• Check that the power supply is switched on
• Contact the local Guldmann representative or the Guldmann Service Team
© Guldmann GB/US-1263/01/08 • # 90069
To Next Page
Loading...
