Guldmann GH2 - Swing-kit Operation

8
is using a ladder, it is important that the mat is placed on the step on which
he is standing. If it is not possible to nd a grounding point, the mat and the
bracelet must be used as a minimum.
Only then is it allowed to work with the PC Board or components where it is
possible to come into contact with the PC Board.
1.10 The Swing-kit
Note: If you wish to use the Swing-kit with the GH2 hoist, this must be
specied when ordering.
1. Bring the two hoists as close to each other as
possible.
The lifting hanger is attached to the hook on hoist B.
2. Pull out the free strap and hook from hoist A and
attach it to the eye.
3. Pull out the lifting strap on hoist B a little further and
retract the lifting strap on hoist A.
When the transfer swing has been completed there
is no longer any load on the lifting strap on hoist B.
4. Release the hook and strap from hoist B, which
now bears no load.
Return the lifting strap to hoist B until the hook is
needed again.
5. Return the lifting hanger on hoist A to working
height. The transfer through the door has now
been completed.
A B
A B
A B
A B
A B
© Guldmann GB/US-1263/01/08 • # 90069
© Guldmann GB/US-1263/01/08 • # 90069