1. To fill water:
The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa as shown.
This is a pressure balance valve that requires you to lift the handle to start the water flow and to adjust to the
temperature that is desired. The clean jet motor must be completely submerged in water.
CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2. To Auto Fill
With drain open. Turn on water with mixer valve handle
Press auto fill air switch (brown & chrome)
Adjust mixer for desired water temperature
Close drain valve, bowl will fill to set water level and shut off
Mixer valve is now set open and at temperature setting for the rest of the day
*Mixer valve must be turned off at the end of the day
3. To start whirlpool:
Press the jet button as shown. This will start your Clean Jet motor. You may stop the whirlpool function at any time by
pressing the button again.
4. The foot-spa is equipped with a hand held sprayer. To activate the hand shower, pull the hand shower
from the receptacle and depress the thumb control on the sprayer handle. This will turn on the water. When you
release pressure on the thumb control this will turn the water off.
5. To drain whirlpool tub:
The spa is equipped with a built in optional discharge pump. Open the drain plug by turning the control knob as
shown. Press discharge pump timer button as shown (pump will run for approx. 2 min.)
Average time for drain is 1 minute.
6. 9600 & 9700 chairs Shiatsu Roller back massage is equipped with a state of-the-art massage system. The massage
system is easy to use; the remote has a one touch power that starts select your own massage. You can also adjust
the front to rear position of the chair and the reclining back. By using the remote your client can adjust the back to the
most comfortable position.
13
Control Panel
Jet (On/Off)
Water Mixer Control
Drain Control
Hand Spray
OPERATIONS & USE
11
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:
1. Read and follow all instructions
2. DANGER. To reduce the risk of injury, do not permit children to use this unit unless they are supervised at all
times
3. Use this unit only for its intended use as described in this manual. Do not use attachments that are not
Recommended by the manufacturer.
4. Never drop or insert any object into any opening.
5. Do not block jets during whirlpool operation.
6. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
7. The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.
Save these instructions
Discharge Control
(Optional)
To Next Page
Loading...
