IR Remote control
* The P26 preamp uses the new remote control, please press and hold the AMP button
for more than 3 seconds to enter the P26 preamp operation mode.
① Mute button: In the default state, press this button, the P26 Preamp will enter
the mute state; when the P26 stage is in the mute state, press this button to
unmute.
② Menu button: Press this button to enter the function setting menu of P26 Preamp.
③ Four-way and OK button: When entering the menu of P26, use up / down to switch the
function to be adjusted, and adjust the options by left / right. Press the middle
button to confirm the adjustment result and return to the main page screen.
④ Back button: Returns to the main page state.
⑤ Volume minus button: When the P26 Preamp is in the main page state, press this
button to decrease the volume.
⑥ Volume plus button: When the P26 Preamp is in the main page state, press this
button to increase the volume.
Note: ● The operating distance varies depending on the angle. ● If there is something between the remote control
and the IR sensor, it may not operate normally. ● If the remote control will not be used for a long time (one
month or longer), remove the battery. ● If the battery Leaking, please thoroughly clean all the residues in the
battery compartment and install new batteries. ● When using other devices controlled by infrared rays, using
this remote control may operate these devices by mistake.
To Next Page
Loading...
